Sony PEG-TG50 Benutzerhandbuch

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

An event created in the “Date Book” application cannot 
be listed in the week view

B In the Week view, you cannot select overlapping events that have the same 

start time. If you have two or more events with the same start time, select 
the Day view to view overlapping events.

I cannot transfer vCard data created with the “Address” 
application on my CLIÉ handheld

B The vCard data created with the “Address” application on your CLIÉ 

handheld cannot be read by the Palm™ Desktop for CLIÉ software 
because of its format “ver3.X.” When you want to transfer Address data to 
the Palm™ Desktop for CLIÉ software on your computer, perform a 
HotSync

®

 operation (the vCard data created with the Palm™ Desktop for 

CLIÉ software can be read by the “Address” application on your CLIÉ 
handheld). When you transfer vCard data to a device other than a CLIÉ 
handheld, the data may not be displayed properly on the device if the data 
version is not supported.

Performing initial checks

B Tap General in the Preferences screen and check that Beam Receive 

is set to ON.

B Make sure you point the IR port of your CLIÉ handheld directly at the IR 

port of the target device.

B The distance between the devices is not correct.

Make sure the distance between your CLIÉ handheld and the target device 
is 4 to 8 inches (approximately 10 to 20 centimeters). Best results of 
beaming distance may vary depending on compatibility between devices.

B When transmitting multiple files using the IR port, the contents of each file 

may be replaced with one another. Send one file at a time to avoid this.