Sony CMD-J16 Benutzerhandbuch

 

 
 

•  Select “file”/”Settings…” and check if the settings for the “Com Port”and “Speed” are correct. 

 

− The FlashLoader automatically detects all available Com ports on the PC. 

(COM 1 or COM 2) 

 

− Baud rates up to 812500bps will be supported, but standard PCs, unless  

it is correctly customised (i.e. with a Fast Serial Board), will not support  
Baud rates > 115200bps. 

 
 

− The default values are 

 
 

 

•  Click on the “Load” button and select an SRE file for downloading. 

− The CMD-J5/J16 software is located in the J5.SRE file. 

− Any other SRE file is either only needed for the program itself, or can be a personal data file. 

 

 

− 

Flash erase area is automatically calculated with the contents of the file.

 

 

•  Switch on the CMD-J5/J16. 

 

•  Now the program runs automatically. 

 
 

∗ Save Personal Data in Mobile (Get Data / Write Data)

 

The set-up and all requirements for this data transfer are the same as for the software update. 

 

•  Check if the settings for the “Com Port” and “Speed” are correct. 

 

•  Click on “Get Data”. 

 

•  Switch on the CMD-J5/J16. 

 

•  When the read data is downloaded either reload it in another mobile (reconnect a new mobile and click on 

“Write Data”) or save it on the disc using File/Save option. 

 
 

∗ Reset of Personal Data (Erase Data)

 

The set-up and all requirements for this data transfer are the same as for the software update. 

 

•  Check if the settings for the “Com Port” and Speed” are correct. 

 

•  Click on “Erase Data”. 

 

•  Switch on the CMD-J5/J16. 

 

• 

All individual settings (such as Phonebook entries

 

and WAP settings etc.) will be deleted.

 

 
 

∗ Reset of Security Code Lock (Clear Lock)

 

The set-up and all requirements for this data transfer are the same as for the software update. 

 

•  Check if the settings for the “Com Port” and Speed” are correct. 

 

•  Click on “Clear Lock”. 

 

•  Switch on the CMD-J5/J16. 

 

• 

The individual Security Code will be reset to the default setting: 0000 !