Transcend Information 610 Benutzerhandbuch

 32

 
 

If an error occurs, first check the information listed below before taking your T.sonic for repair. If 
you are unable to remedy a problem from the following hints, please consult your dealer, service 
center, or local Transcend branch office. 

Enter Device Manager in the Control Panel and enable the Auto-Insert function of the CD-ROM 
drive. Alternatively, you can manually execute the T.sonic.EXE from the driver CD. 

Check the followings: 

1. Is 

your 

T.sonic properly connected to the USB port? If not, unplug it and plug it in again. 

2. Is your T.sonic connected to the Mac keyboard? If yes, unplug it and plug it into an available 

USB port on your Mac Desktop instead. 

3.  Is the USB port enabled? If not, refer to the user’s manual of your computer (or motherboard) 

to enable it. 

4.  Is the necessary driver installed? If your computer is equipped with Windows 98SE, you must 

insert the Driver CD into the CD-ROM and refer to the “Driver Installation for Windows 
98SE” section to complete the driver installation before using your T.sonic. A driver is not 
required for Win ME/2000/XP, Mac OS 9.0 or later, or Linux kernel 2.4 or later 

Check the following: 

1. Is 

the 

T.sonic connected to your computer? If yes, unplug it. 

2. Is 

the 

LOCK switch set to “HOLD”? If yes, set it to “OFF”. 

As required, uninstall the driver and re-install it. If it doesn’t work, see Recover T.sonic to format 
your T.sonic. 

Check to see if the LOCK switch is set to “HOLD ”. If yes, set it to “OFF”. 

Check the following: