Roberts Radio CRD-37 Benutzerhandbuch
5
Using the clock radio for the fi rst time
1. Place your clock radio on a fl at surface.
2. Fully extend the wire aerial located on the rear of your clock radio. The
wire should be fully extended and positioned for optimum reception.
3. Insert the adaptor plug into the DC socket located on the rear of your
clock radio.
4. Plug the adaptor into a standard 13amp mains socket outlet.
IMPORTANT: The mains adaptor is used as the means of connecting
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the mains adaptor should
be removed from the mains socket outlet completely.
the clock radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to disconnect
the clock radio from the mains completely, the mains adaptor should
be removed from the mains socket outlet completely.
5. When your clock radio is fi rst switched on the display will show "Setting
Clock" and a station search will be performed automatically.
6. When stations have been found, the clock information will appear on
the display. Press the Display button to toggle between showing the
time only or showing both the date and time.
time only or showing both the date and time.
7. If no stations have been found "Clock not set" will be displayed. It may
then be necessary to relocate your clock radio to a position giving better
reception. You should then carry out an autoscan to fi nd stations as
described on page 9.
reception. You should then carry out an autoscan to fi nd stations as
described on page 9.