Beko DRCT 70 W Benutzerhandbuch

17

EN

This function allows for drying at lower 

temperatures and therefore saves energy.
Warning LED will light up when you select 
the function.

C 

You must use this function when you 

dry your synthetic or delicate laundry.

C 

Warning indicators may differ 

according to the model of your 

machine.

A warning LED will light up to remind filter 

cleaning after the programme finishes.

C 

If the filter cleaning warning LED 

lights up continuously, please refer to, 

“Solution suggestions for problems”.

A

 warning LED will light up at the end 

of the programme or when the tank is full 

with water. The machine stops operating 

when this warning LED lights up during 

a programme running.  To restart the 

machine, please drain the water in 

the water tank.  Press “Start/Pause/

Cancel” button to start the programme 

after you have emptied the water tank. 

The warning LED goes off and the 

programme resumes operating.

1. Press “Start/Pause/Cancel” button to 

start the programme.

2. “Start/Pause/Cancel” button will light 

up to indicate that the programme has 

started.

One of the LED lights will remain on as 

far as programme runs and shows the 

approximate remaining time. 

C

LEDs on the timer follow-up indicator 

will also flash when the child-proof lock 

is activated.

You can use this feature to dry your 

laundry in a different programme after 

your machine has started to run.

For example;

Press and hold the “Start/Pause/Cancel” 

button for about 3 seconds to select 

“80” minutes programme instead of “60” 

minutes programme 

Select the “80” minutes programme by 

rotating the programme knob.

Press “Start/Pause/Cancel” button to 

start the programme.

C 

The programme which is selected 

first will go on even if the programme 

selection button is moved and another 

programme mode is selected while the 

machine is operating. You must cancel 

the ongoing programme in order 

to change the drying programme. 

(See, Ending the programme through 

cancelling)

In order to add or take out laundry after 

the start-up of the programme

1. Press the “Start/Pause/Cancel” button 

to switch the machine to “Pause” 

mode. Drying process will stop.

2. Open the door at Pause position and 

close it again after adding or taking out 

laundry.

3. Press “Start/Pause/Cancel” button to 

start the programme.

C

  Any laundry added after the drying 

process was started may cause the 

already dried clothes in the machine 

intermingle with wet clothes and the 

result will be wet laundry after the 

drying process is over.

C

 Laundry may be added or taken 

out as much as desired during a 

drying process, but as this process 

will interrupt drying continuously, it 

will extend the programme  duration 

and increase energy consumption. 

Therefore, it is recommended to add 

laundry before the drying programme 

is started.

There is a childproof lock to prevent any 

programme interruption due to the 

pressing of keys while the programme 

is on. The loading door and all keys 

except the “On/Off” key on the panel 

are deactivated when the child-proof 

lock is active.