Sony 3-287-969-15 (1) Benutzerhandbuch

Seite von 167
32
If dust or debris enters the camera and lands on the image sensor (the part 
that acts as the film), it may appear on the photo image, depending on the 
shooting environment. If there is dust on the image sensor, use a 
commercially available blower and clean the image sensor following the 
steps below. You can easily clean the image sensor using only the blower 
and the anti-dust function.
Notes
• Cleaning can be performed only when the battery level is 
 (three remaining 
battery icons) or more. Low battery power during cleaning can cause damage to the 
shutter. The cleaning should be completed quickly. The use of an AC Adaptor/
Charger (not supplied) is recommended.
• Do not use a spray blower because it may scatter vapor inside the camera body.
Cleaning the image sensor
1
Confirm that the battery is fully charged (page 17).
2
Press the MENU button, then 
select  
with 
b
/B on the 
controller.
MENU button
3
Select [Cleaning mode] with v/V 
on the controller, then press the 
center of the controller.
The message “After cleaning, turn 
camera off. Continue?” appears.
4
Select [OK] with v on the controller, and press the center of the 
controller.
After the image sensor vibrates for a short time, the mirror in front is lifted.