Tekxon Technology K3 Benutzerhandbuch

 

 

 

 

 

  

If there is not enough available light for your photo, the built-in flash can provide the additional 
light required. 

1 

Switch the camera on and select the photo mode (single shot or self-
timer mode). 

2 

Press the right button   once or repeatedly to set one of three flash 
modes. The flash mode changes from “Auto” to “Always on” to “Off” 
each time you press the button. The corresponding status symbol for 
the flash mode is shown in the upper left corner of the LCD. 

 

 

The flash is activated automatically when the light level is too low if 
the flash is set to “Auto”. When “Always on” is set the flash is used 
for every shot. When “Off” is selected, the flash is deactivated. 
The flash only works in single shot mode and self-timer mode. 
It does not work in burst and video mode. 
Please note that using the flash increases battery consumption. 

 

In photography mode, you can access the “Single” 

, “SelfTimer” 

 and “Sequence” 

 

modes by pressing the left button 

 repeatedly. The corresponding symbol is displayed at 

the top left of the LCD. 
 

In photography mode, the OK button can be used to select the resolution progressively. The 
current resolution is displayed at the top left of the LCD. 
 

You can set the flash to “Auto” 

, “Always on”   or “Off” 

 by  

pressing the right button   in single shot and self-timer modes.  
The corresponding symbol is displayed on the LCD.