D-Link DCS-2100+ Benutzerhandbuch
92
There is a button hidden in the pinhole beside the Ethernet socket. It is
used to reset the system or restore the factory default settings.
Sometimes resetting the DCS-2100+ will return the system back to a
normal state. If the system still has problems after reset, restore the
factory settings and install again:
used to reset the system or restore the factory default settings.
Sometimes resetting the DCS-2100+ will return the system back to a
normal state. If the system still has problems after reset, restore the
factory settings and install again:
RESET:
1. Lightly insert a paper clip (or a similar sized tool) into the
reset hole on the back of the camera, press lightly and
then release the button.
2. The LED on the front of the camera will begin blinking red
and green.
3. When the LED stops the blinking the reset has completed.
reset hole on the back of the camera, press lightly and
then release the button.
2. The LED on the front of the camera will begin blinking red
and green.
3. When the LED stops the blinking the reset has completed.
RESTORE: 1. Insert the paper clip or other tool and press on the button
continuously.
2. Wait for the LED on the front of the camera to blink red
and green and hold the button through two cycles of
blinking (about 5-7 seconds.)
3. Withdraw the tool after the second cycle of the LED
blinking and a factory restore has been completed.
2. Wait for the LED on the front of the camera to blink red
and green and hold the button through two cycles of
blinking (about 5-7 seconds.)
3. Withdraw the tool after the second cycle of the LED
blinking and a factory restore has been completed.
Reset and Restore
Reset button
Restoring the factory defaults will result in the
loss of any previous settings and will require
running the IP Installer to return the
DCS-2100+ to a normal state.
loss of any previous settings and will require
running the IP Installer to return the
DCS-2100+ to a normal state.