Phantom Tech SU0508L Benutzerhandbuch

Cutting the 

Screen

 

Housing Assembly

                                             

It is easy to cut right through the Screen Housing Assembly
of the Sure View Screen using a chop saw or hacksaw.

NOTE: All cutting will be done on the upper end
of the Screen Housing Assembly. The Mounting
Bracket on the Screen Housing Assembly is
clearly labeled with CUT and NO CUT zones.

1.  Remove the Mesh Lock Adjuster and Sliding
 

Bar Top Cap from the Screen Housing Assembly by

 

removing their screws with a Phillips screwdriver. (A)

2.   Detach the Sliding Bar from the Sliding Bar Bottom Cap,
 

and slide it towards the upper end of the Screen Housing

 

Assembly until it is aligned with the top of the Assembly

 

and the mesh. (B)

3.   Slide the Mounting Bracket until its upper edge
 

is aligned with the upper edge of the Screen

 

Housing Assembly. (C)

4.   With all components aligned, carefully
 

measure and mark the Screen Housing,

 

Sliding Bar and Mounting Bracket on all

 

sides based on the “Length to be cut” dimension

 

calculated on Page 7. (D)

5.   Wearing safety glasses, cut straight through
 

all components of the assembly. Use a file to

 

remove any burrs from the cut surfaces.

6.   Re-attach the Sliding Bar onto the Sliding
 

Bar Bottom Cap. (B) Make sure that it is

 

pushed in as far as it will go.

7.   Re-attach the Mesh Lock Adjuster and Sliding Bar
 

Top Cap to the Screen Housing Assembly and

 

replace the screws. (A)

8.   Slide the Mounting Bracket completely off the
 

Screen Housing and set aside.

9

Catch Frame

Length

to be cut