Hearth & Home Technologies GBI25 Benutzerhandbuch

Seite von 24
26678 Rev H
2
02-02
GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT
CAUTION:
Do not expose the appliance to the elements (such as rain, etc.)
SAFETY  PRECAUTIONS
1. Please read these installation instructions completely
before  beginning  installation  procedures.  Failure  to
follow  them  could  cause  a  malfunction  resulting  in
serious  injury  and/or  property  damage.
2. Installation and repair should be done by a qualified
service  person.  This  appliance  should  also  be
inspected annually by a qualified service person. More
frequent  inspections/cleaning  may  be  required  due
to excessive lint from carpeting, bedding material, etc.
It  is  imperative  that  the  control  compartment  and
burners of the appliance be kept clean.
3. The  GBi25is  a  vented  gas  appliance.  Do  not  burn
wood or other material in this appliance.
4. NEVER  leave  children  unattended  when  there  is  a
fire burning in the fireplace.
5. This appliance must be vented with a minimum 4” B-
Vent system and must terminate above the roof line.
Venting  must  not  be  connected  to  a  chimney  flue
servicing  a  solid  fuel  burning  appliance.
6. Use only the fuel gas specified on the rating label of
this  gas  appliance.
7. The appliance area shall be kept clear and free from
combustible materials, gasoline and other flammable
vapors  and  liquids.
8. While  servicing  this  appliance,  always  shut  off  all
electricity and gas to the appliance. This will prevent
possible  electrical  shock  or  burns. Also,  make  sure
the fireplace is completely cooled before servicing.
9. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
10. Be  sure  to  provide  adequate  clearances  around  the
air  openings  into  the  combustion  chamber  and
adequate  accessibility  clearances  for  servicing  and
proper  operation.
11. Provisions  shall  be  made  to  provide  adequate
combustion and ventilation air. The flow of combustion
and ventilation air should not be obstructed.
Contents
K. Optional Components ........................................................................................................... 19
Index ...................................................................................................................................... 23
Warranty ................................................................................................................................ 24