Samsung AW09LH Series Benutzerhandbuch

Seite von 24
22_ installing
installing your air conditioner
GETTING READY TO INSTALL THE AIR CONDITIONER
First select a room and check conditions prior to installation.
Checking included parts
Check that all necessary parts are included. Actual accessories may slightly differ from the 
illustration shown below.
Gasket
Drain tube
Rubber cap
Screws
Selecting the best location
The unit should be level when installed, so that the drainage system and other mechanisms 
operate efficiently. If possible, install the unit in a shaded area on the home’s north or east side.
Before installation, select a location that fulfills these requirements:
•  easy access to control panel.
•  away from direct exposure to sunlight.
•  adequate ventilation.
•  can easily connect to a power source.
•  can support the weight of the air conditioner and will not cause increased operating noise 
and vibration.
•  where there is no obstacles near the air inlet and outlet.
•  the bottom of the unit clears at least 750 mm above ground level.
500mm
500mm
750mm
75mm  
min.
300mm
500mm
about 3˚
150mm min.
145mm
awning
If the wall is thicker than 150mm,  
cut the back of the wall at 45°.
100mm or more
Outdoor side
Indoor side
45˚
45˚
Outdoor side
Indoor side
<Fence, wall 
 or other 
obstacles>