Samsung AW07P1HBA Benutzerhandbuch

E-

Installation of the Drain Tube
Fix the drain tube as shown in the figure.

Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the
condition of the installing area.

1 Open the front grille; refer to page 9.

3 Remove the front panel.

4 Remove two screws on the lower, right and left sides of the unit.

5 Remove the chassis from the cabinet.

6 Remove the rubber cap inserted into the basepan.

7 Fix the drain pan as shown in the figure, and then connect the drain hose.

(You can use any commercially-available drain hose.)

8 Install the cabinet at the specified area after installing the drain pan,

and then re-assemble it in the original condition.

1 Follow steps 6 and 7 only

Remove the screw located at the lower section of the front grille.

It is secured in the section depending on the model.

In the case of an area where the drain pan can not be directly

installed on the rear side of the unit after installing the air conditioner.
Example: High storage

In the case of an area where the drain pan can be directly installed

on the rear side of the unit after installing the air conditioner.

3-1 Press both sides of the cabinet in the direction of the arrow

as shown in the figure.

3-2 Pull the lower part of the front panel slightly forward.

(below three inches)

3-3 Lift the front panel upward.

Applying excessive force to remove the front panel may cause

damage to the tab; be sure not to use excessive force.

Secure the front panel to the case by replacing the screw removed in
step 2. If a screw not removed in step 2. secure the panel with a
supplied screw.

Rubber cap

Screws(2EA)

Gasket

Rear

Drain Tube

Bottom-Side View with

Drain Pan and Hose in Place

Rubber cap

Drain Hose

Rear

Drain Pan

Screw

HSI