Runco SC-30d Benutzerhandbuch

1.

PROJECTION LENS
The inside of the lens barrel is threaded to accommodate a standard, 72-mm lens 
filter. For example, with a smaller screen you can install a neutral-density filter to 
reduce the overall light output. 

2.

VERTICAL LENS SHIFT CONTROL 
To access the vertical lens shift control, insert the included 5.0-mm Hex wrench into 
this opening and turn it as needed to shift the lens in the desired direction (refer to 
Primary Lens Adjustments: Focus, Zoom and Position on page 51). 

3.

RUNCO LOGO
The logo can be rotated to match the projector orientation: inverted (ceiling-mounted) 
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and 
rotate it 180 degrees. 

4.

EXHAUST VENT
Warm air exits the projector through this vent. Ensure that it is not blocked. 

5.

HORIZONTAL LENS SHIFT CONTROL 
To access the horizontal lens shift control, insert the included 5.0-mm Hex wrench 
into this opening and turn it as needed to shift the lens in the desired direction (refer to 
Adjusting the Focus, Zoom and Position of the Primary Lenses on page 54). 

6.

INTAKE VENT
Internal fans draw cool air into the projector through this vent. 

7.

CEILING MOUNTING HOLES
Use these to attach the ceiling bracket (if needed) to the projector. 

8.

CABLE OPENING
Pass cables through this opening. 

Figure 2-3 shows the SC-30d/SC-35d rear panel.

RS232

RS232

PRIMARY

PRIMARY

SECONDARY

SECONDARY

1

2

3

4

6

5

7