Runco SC-30d Benutzerhandbuch
Runco SC-30d/SC-35d Installation/Operation Manual
49
PRE
L
IMINAR
Y
Connecting the Active 3D
Emitter to the Dimension
Digital Controller
Emitter to the Dimension
Digital Controller
Connect the 3D SYNC IN port on the emitter to the 3D SYNC connector on the
Dimension Digital Controller, as shown in Figure 3-25.
Dimension Digital Controller, as shown in Figure 3-25.
Figure 3-25. Active 3D Emitter Connection
Connecting to AC Power
Projector/Dimension Digital Controller: Plug the female end of one power cord into
the AC receptacle on the rear of the SC-30d/SC-35d (AC 100V ~ 240V). Then, connect
the other end to your AC power source.
the AC receptacle on the rear of the SC-30d/SC-35d (AC 100V ~ 240V). Then, connect
the other end to your AC power source.
Similarly connect the Dimension Digital Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
Secure the emitter in the desired location using double-sided tape or
a similar adhesive material.
a similar adhesive material.
Tip
USB
Video 1
Y
Video 2
Video 3
Pr
Pb
HDMI 2
Component / SCART
TRIGGERS
1
2
3
HD1
3D SYNC
HD2
DisplayPort
USB
Video 1
Y
Video 2
Video 3
Pr
Pb
HDMI 2
Component / SCART
TRIGGERS
1
2
3
HD1
HD2
DisplayPortrr
Active 3D Emitter
3D
SYNC IN