Sony CDX-CA810X Benutzerhandbuch

Seite von 56
26
Error displays/Messages
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set to the monaural reception mode (page 
18).
A program broadcast in stereo is heard in 
monaural.
• The unit is in monaural reception mode.
t Cancel monaural reception mode (page 
18).
Interference occurs during FM reception.
The wide mode is selected.
t Set the IF mode to “IF AUTO” (page 18).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about 
5 seconds, and an alarm sound will be heard.
BLANK
*
1
No tracks have been recorded on an MD.*
2
t Play an MD with recorded tracks on it.
ERROR
*
1
• An inserted CD is dirty or inserted upside 
down.*
2
t Clean or insert the CD correctly.
• An inserted CD/MD cannot play because of 
some problem.*
2
t Insert another CD/MD.
FAILURE 
(Illuminates until any button is 
pressed)
The connection of speakers/amplifiers is 
incorrect.
t See the installation guide manual of this 
model to check the connection.
FAILURE 
(Illuminates for about 1 second)
When the XM tuner is connected, storing an 
XM radio channel into a preset failed.
t Be sure to receive the channel that you 
want to store, then try it again.
HI TEMP
The ambient temperature is more than 50°C 
(122°F).
t Wait until the temperature goes down 
below 50°C (122°F).
NO DISC
No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.
NO MUSIC
A CD which is not a music file is inserted in 
the MP3 playable CD unit.
t Insert a music CD in the MP3 playable CD 
unit.
NOTREADY
The lid of the MD unit is open or the MDs are 
not inserted properly.
t Close the lid or insert the MDs properly.
OFFSET
There may be an internal malfunction.
t Check the connection. If the error 
indication remains on in the display, 
consult your nearest Sony dealer.
RESET
The CD/MD unit cannot be operated because 
of some problem.
t Press the RESET button on the unit.