Sony PDW-R1 Benutzerhandbuch

Cha

p

te

r 4  

 Rec

o

rd

ing/

Pl

a

y

bac

k

49

4-2 Playback

This section describes playback of video and audio.

Although this unit uses optical discs, it is designed to offer 
the most convenient features of tape playback by VTRs. 
One of these is the playback start position, which works in 
the same way as tape, as described below.

After playback stop
The unit stops at the position where the STOP button was 
pressed.
Press the PLAY button to resume playback at the stop 
position.

After recording
The unit stops at the position where recording ended.
To play back a clip, press the PREV button to move to the 
start frame of any clip, or press the PREV button with the 
PLAY button held down to move to any position.

After disc insertion
The unit stops at the position of the disc when it was most 
recently ejected.
Press the PLAY button to resume playback at the most 
recent position.
The playback position is saved to the disc when the disc is 
ejected, which allows playback to start at that position 
whenever it is loaded into any XDCAM player.

This function is not available when the Write Inhibit tab of 
the disc is set to the recording disabled position, and when 
extended menu item 310 “REC INHIBIT” is set to “on.”
The REC INHI indicator may light when neither of the 
above are true if the format of recorded sections on the disc 
is not the same as the recording settings of this unit. In this 
case, the playback position can be saved to the disc.

Before beginning playback, make any necessary button/
switch settings.

a Remote control switch (page 12)
Set to LOCAL.

b On/standby switch (page 12)
Indicator (`) lit green.

c VARIABLE switch (page 15) and ALL/CH-1, CH-

Adjust the audio playback levels.

d AUDIO MONITOR SEL button (page 15)
Select the audio channels to monitor.

e AC power switch (rear panel) (page 11)
Set to the ` (on) position.
If you are using DC power or a battery pack, connect the 
DC power or mount the battery pack on the battery pack 
shoe before playback.

f COUNTER SEL button (page 13)
Select the data (elapsed playback time, time code value or 
user bit data) to be displayed in the time data display. 
When displaying the time code value, select TC or VITC 
with extended menu item 629 “TC SELECT.”

You can adjust the following video processing parameters.
• Video output level
• Chroma output level
• Setup/black level
• Chroma phase
• Output signal sync phase
• Output signal subcarrier phase

1

2

3

4

5

6