Axor 16513XX1 Montageanweisungen
3
Installation Considerations
For best results, Hansgrohe recom-
mends that this unit be installed by a
licensed, professional plumber.
Please read over these instructions
Please read over these instructions
thoroughly before beginning instal-
lation. Make sure that you have all
tools and supplies needed to complete
the installation.
This faucet may be used with a con-
This faucet may be used with a con-
tinuous flow water heater as long as
the flow pressure is at least 14.5 psi.
•
•
•
Technical Data
Max. flow rate
2.2 gpm
Max. water pressure
145 psi
Recommended pressure:
14.5 - 72 psi
Max. hot water temperature:
176° F
Recommended hot water temp.
120°F - 140°F*
Hole size in mounting surface
valve
1 1/4"
spout
1 3/8"
Maximum mounting surface depth 1 5/8"
Requires 1/2" supply lines and nuts.
Bidet faucet not for use on vertical spray bidets.
*Please know and follow all applicable local codes when setting
the temperature on the water heater.
Installation
Remove the mounting ring with o-ring and stop
ring from the valve body.
Push the valve up through the hole in the mounting
Push the valve up through the hole in the mounting
surface.
Install the stop ring on the valve. Install the
Install the stop ring on the valve. Install the
mounting ring -- it will stop at the proper mounting
height.
Rest the valve on the mounting surface.
Tighten the mounting nut and the tensioning
Tighten the mounting nut and the tensioning
screws.