Profile PCD970R Benutzerhandbuch

9

If you own a Japanese vehicle, you can use the standard ISO/DIN mounting screw holes on 
the side of the CD player to attach to the existing factory mounting bracket, without using 
the provided DIN sleeve. 

  Remove the factory ISO/DIN mounting bracket from the car along with the factory radio.
  Remove the factory radio from the bracket by unscrewing the two Phillips screws on each 
  side of the radio paying close attention to their screw positions and saving the screws to 
  mount the CD player.
  Remove the two spring clips from each side of the CD player by removing the screws. 
 These clips are not used in ISO/DIN mounting method and must be removed to expose the
 ISO/DIN mounting holes.

  Also remove the detachable face and rectangular trim ring from the CD player and mount
  the CD player to the factory ISO/DIN bracket using the screws that you removed from
  the factory radio.

  Connect the wire harness and antenna plug to the back of the CD player. Then mount the 
  factory ISO-DIN bracket to the car.

  Note:   It is not necessary to attach the outer rectangular trim ring for ISO/DIN mounting
              method.

  To remove the CD player from an ISO/DIN mount, follow the above mounting procedure
  in reverse order.

  To remove the CD player from a sleeve mount, use the pair of keys provided.

Remove the rectangular trim ring by 
applying pressure with your finger 
tips, then gently pull out away from 
the dash.

Insert the provided removal key into the opening on each side of the CD player. 
Push the keys inward until they snap in place.  Firmly grab the keys and slowly 
pull the CD player out away from the dash. 

PLACE FINGER TIPS HERE

!
!

!  

!  

!

!

!