Sony SNP-3350 Benutzerhandbuch
NETWORK PTZ CAMERA
User Guide
48
NETWORK PTZ CAMERA
User Guide
49
Chapter 4. Using Web Viewer
• Depending on the type of video, enter an address as from the examples in the following
chart, and then click Play (P). (When using the default RTSP port number, 554, you may
skip entering the port number.)
chart, and then click Play (P). (When using the default RTSP port number, 554, you may
skip entering the port number.)
The followings are examples of addresses for network streaming.
Address
Streaming Engine Settings
rtsp://<IP>:<SERVICE PORT>/mpeg4unicast
For RTSP/TCP and RTP/UDP
rtsp://<IP>:<SERVICE PORT>/mpeg4multicast
For RTSP/Multicast
<IP> : The current camera IP
<Service Port> : The number of the service port +1 that is selected at the
Config Setup → Network menu.
ex) default port : 80 → <SERVICE PORT> : 81
※When using the default RTSP port number, 554, you may skip entering
the port number.
Notes
• New settings are saved only if you click the
button at the bottom of the screen.
Apply The
button cancels new settings.
Caution
4.2.1.3 Motion Detection
Configure the camera’s Motion Detection operation.
Category
Description
Enable
Check to enable Motion Detection.
Sensitivity
Select a sensitivity level for motion detection according to the video display
settings. 5 levels are available, and 5 is the most sensitive.
settings. 5 levels are available, and 5 is the most sensitive.
: Selected Area, : Other Areas.
Notes