Shindaiwa EB854RT Benutzerhandbuch

7

Before assembling the blower, make 

sure you have all required components. 

Power unit and blower assembly.

 

■

Flexible tube, swivel tube, two noz-

 

■

zles and straight tube.
Handgrip.

 

■

The terms “left”, “left-hand”, “LH”; 

“right”, “right-hand”, and “RH”; “front” 

and “rear” refer to directions as 

viewed by the operator during normal 

operation.

Two tube clamps (102 and 89 mm).

 

■

This Owner’s/Operator’s Manual 

 

■

and a tool kit containing a tool 

bag, 4 mm hex wrench, 5 mm hex 

wrench and a combination spark 

plug wrench/screwdriver.
Lead wire assembly (anti-static).

 

■

This unit is equipped with a static  

discharge reduction wire. This wire 

helps direct static buildup into the air 

stream reducing the felt amount to the 

operator. 

Place the blower upright on the 

1. 

ground or a sturdy work surface and 

note parts orientation as shown in 

Figure 4.
Remove static wire from package 

2. 

and fix eyelet to right hand engine 

cover screw. See Figure 5.
Turn the discharge tube out to a 

3. 

right angle and slip anti-static wire 

through the 102 mm clamp and flex-

ible tube.
Slip the flexible tube over the end of 

4. 

the 90° discharge tube, and secure 

with the 102 mm clamp.

Insert the static wire through the 

5. 

swivel tube, then install and tighten 

the 89 mm clamp over the rotating 

band on the swivel tube.
Slide the handgrip over the swivel 

6. 

tube and secure with the bolt and 

wingnut.
Fold the end of the static wire back 

7. 

over the connection of the swivel 

tube. See Figure 5. 
Grasp the straight tube, and push 

8. 

the straight tube over the swivel 

tube locking pins securing the static 

wire. See Figure 6.
Lock the straight tube to the swivel 

9. 

tube by rotating the straight tube 

noting the alignment marks. See 

Figure 6.

Check to make sure that the 90° dis-

charge tube swivels freely. If any bind-

ing is present, loosen 102mm clamp 

and pull wire towards engine to get 

more slack  and recheck for free 

movement.

Blower tube installation affects blower 

performance! Make sure the tubes and 

straight tube are correctly assembled 

per above, and that all connections are 

tight. Blower tubes may come apart 

during use unless tubes are aligned 

and locked into place. 

ler! Stop the engine before installing 

of removing the blower tubes! Never 

perform any maintenance or assem-

bly procedures on this unit while the 

engine is running!

Grasp the nozzle, and push the 

10. 

nozzle over the straight tube locking 

pins.  See Figure 6.

Lock the nozzle to the straight tube 

11. 

by rotating the nozzle noting the 

alignment marks. See Figure 6.
Adjust handgrip for best operator 

12. 

comfort, and tighten securely.

Carefully inspect all components for 

damage.

Optional           

Long Nozzle 

(ø74 mm)