Jacuzzi HD84000 Benutzerhandbuch

Luxury Whirlpool Bath

Installation and Operation 

www.jacuzzi.com

 

Page 19

  Do not use oil or oil-based bathtub additives.

If you want to use any kind of bathtub additive, use only a small amount of low-foaming powder or crystal substance; 

the whirlpool action intensifies the foaming properties of soaps. 
The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub 

residue in the whirlpool system and may cause false reading of the water level sensors. If excess accumulations  

persist, you should discontinue use of these products.

To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub be 

cleaned at least twice a month. For best results, however, we recommend that you clean your whirlpool bathtub after 

each use using, Systems Clean™, our exclusive two-part plumbing system cleaner made specifically for whirlpool 

bathtubs. Systems Clean™ is available through an authorized Jacuzzi Whirlpool Bath Distributor or by calling us direct 

at 1-800-288-4002.

RapidHeat™

The heater turns ON automatically any time whirlpool operation is active. Heater operation is not displayed on the 

control panel. There is a visible indicator light on the heater itself that signifies the heater is operating. The heater will 

help maintain the temperature of the water in the bathtub.

The heater is equipped with a preset vacuum switch which will not allow the heater to turn ON if the pump is not  

running and water is not flowing through the whirlpool system.

The heater includes an exclusive High-Limit switch. This 

safety circuit will not false trip from hot tap water. It will  

only turn OFF the heater if the thermostat fails. To reset, 

press the button. If the high-limit trips frequently, please 

contact us at www.jacuzzi.com, or at 1-800-288-4002.

High Limit 

Reset

Heater 

On