Jacuzzi K272000AF 7/06 Benutzerhandbuch
E
N
G
L
IS
H
UNDERMOUNT INSTALLATION INSTRUCTIONS
Installation
A typical installation will have these construction character-
istics.
istics.
COUNTER
ALL FOAM FEET MUST BE IN CONTACT WITH LEVEL FLOOR
Unit Protection
If protective film has been removed, reapply film. For added protection, place a drop cloth or other material in the bottom of bath
for protection. Be careful not to scratch the bath surface.
for protection. Be careful not to scratch the bath surface.
Counter Preparation
NOTE: On pump/motor side of bath, the counter should extend a minimum of 4"
(10,2 cm)
past the outer edge of bath, in order
to clear the pump/motor plumbing extending beyond the rim of the bath.
INSIDE EDGE
OF RIM
MOTOR/PUMP
COUNTER
Position the template so that the cutout oval aligns with the
rim edge.
rim edge.
TEMPLATE
BATH RIM
In this position, using a grease pencil, mark on the bath the
center line positions through the cut out slots. Remove
template. Measure from marked center lines to a fixed point
such as a wall.
center line positions through the cut out slots. Remove
template. Measure from marked center lines to a fixed point
such as a wall.
Transfer these measurements to counter and mark center lines positions. Position template and cut counter for the desired offset.
STUD WALL
MEASURE FROM
CENTERLINE
MARKS TO WALL
A
C
D
B
COUNTER
TEMPLATE
D
B
A
C
COUNTER
BATH RIM
COUNTER
BATH RIM
OFFSET
After cutting is complete, perform any needed routing, edge work or polishing to the counter.
23
Jacuzzi Whirlpool Bath K272000AF 7/06