Anton/Bauer DUAL 2702 Benutzerhandbuch

 

6 

 

Each PowerCharger’s liquid crystal display (LCD) will display the status of each 
battery, as well as, important PowerCharger operating indications.  The following 
information explains the indications which appear in the LCD. 
The levels of the LCD display on each PowerCharger can be obtained by pressing the 
DISPLAY, or in some cases TEST, button on the PowerCharger front panel. 

The Main Display shows the general status of each 
battery mounted to the PowerCharger.  This 
display is immediately returned to following self 
test and after viewing any other screen. 
Both the two position (above) and four 
position Main Displays will show a series of 
dashes when a battery has not been mounted to 
the PowerCharger. 
The Main Display of the PowerCharger will show 
the abbreviated status of each battery on the main 
unit.   

The Signature Display can be viewed by pressing 
and holding the TEST button from the Main 
Display on the PowerCharger to obtain model 
information, Software revision number and 
installation of DDM (discharger). 
The Primary Position Display is obtained by 
pressing the DISPLAY button repeatedly until 
the position number for the battery desired is 
displayed.  This view further identifies the status 
of the battery, its model number (chemistry and 
voltage), as well as current battery voltage. 
The Primary Position Display will additionally 
display the available capacity when a DIGITAL 
battery is used, both in percent and in ampere 
hours. 
The Secondary Position is obtained by pressing 
and holding the DISPLAY button while viewing 
the primary position display.  This Secondary 
display is available only with DIGITAL 
batteries and is used to obtain information 
transmitted from the battery to the charger 
including battery serial number, date of 
manufacture, number of cycles, “learned” 
capacity, type of stage one charging cut-off 
experienced and battery temperature.