Thomas & Betts BPLT15BSCR Benutzerhandbuch

25

26

“P” Die

“U” Die

DA15-U Adapters

(Optional, see 6.3)

T&B Series 15600 Dies

TA03982 B   Page 3 of 7

The tool can be easily carried using either the 
handle or shoulder strap (19) attached to the 
rings (27), see Fig  1 on page 2 
With the tool at rest, proceed as follows:

• Select the appropriate die set for the 

connector  (Ref: Check Thomas & Betts 

instruction sheet for the connector and make 

sure color code of die matches color code of 

connector )

• Insert one die into the die adaptor and one 

die directly into the head 

• Insert the conductor in connector 
• Position the connector between the dies and 

ensure the correct location of the crimp  (See 

connectors instruction sheet for number of 

crimps )

(Refer to Figs  1, 2 & 3)

• Press the operating button (26) to activate the 

motor-pump and advance the lower die  To halt the 

advancement, release the operating button (26) and the 

motor will stop 

(Refer to Fig  3)

• By keeping operating button (26) pressed, the motor 

continues to operate: the ram will gradually move forward 

until the two dies touch 

• It is recommended to continue pumping until the motor 

stops automatically 

• For ease of operation, the tool head can be rotated 

through 180º, allowing the operator to work in the most 
comfortable position 

• By pressing the pressure release button (25), the ram 

will retract and open the dies