Campbell Hausfeld HU502000 Benutzerhandbuch

lOCatIOn
It is extremely important to install the 
compressor in a clean, dry, and well 
ventilated area. The compressor must 
be placed on a firm, level surface where 
the surrounding air temperature will 
not be more than 100°F.
A minimum clearance of 18 inches 
between the compressor and a wall is 
required because objects could obstruct 
air flow.

WIrInG
1.  Local electrical wiring codes 

differ from area to area. Source 
wiring, plug and protector must 
be rated for at least the amperage 
and voltage indicated on motor 
nameplate, and meet all electrical 
codes for this minimum.

2.  Use a slow blow fuse or a circuit 

breaker.

3.  This product is for use on a 

nominal 120 volt circuit and has 
a grounding plug that looks like 
the plug illustrated in Figure 6. 

Make sure the product is connected 
to an outlet having the same 
configuration as the plug. This 
product must be grounded. In the 
event of an electrical short circuit, 
grounding reduces risk of electrical 
shock by providing an escape wire 
for electric current. This product 
is equipped with a cord having a 
grounding wire with an appropriate 
grounding plug. Plug must be 
plugged into an outlet that is 
properly installed and grounded in 
accordance with all local codes and 
ordinances.

TEST

RESET

Grounded Outlet

Grounding Pin

beFOre FIrSt Start-Up
break-In prOCeDUre
(Complete this procedure before using 
compressor for the first time. Once 
completed, it is not necessary to repeat.)
1.  Open drain valve located on bottom 

of tank.

2.  Turn On / OFF switch to OFF 

position.

3.  Plug in power cord.
4.  Turn On / OFF switch to On position 

and run compressor for 30 minutes.

5.  Turn On / OFF switch to OFF 

position.

6.  Unplug power cord.
7.  Close drain valve.
The compressor is now ready for use.

OperatInG prOCeDUre
1.  Turn switch to OFF position and plug 

in power cord.

2.  Turn regulator knob 

counterclockwise to close air flow.

3.  Turn switch to aUtO position.
4.  Compressor will build to maximum 

pressure and shut off.

5.  With hose attached to outlet of 

compressor, attach tire chuck or 
other tool to open end of hose.

6.  Adjust regulator to proper pressure 

for tool or tire. Operate tool per 
instructions. 

As air is depleted from the tank by 
use of a tire chuck, tool, etc., the 
compressor will restart automatically 
at its preset “cut-in” pressure. When 
a tool is being used continuously, 
the compressor will cycle on and off 
automatically.
7.  Turn switch to OFF position, unplug 

power cord and drain tank of air 
when finished using compressor.

Use of an extension cord may cause excess 
heat to motor. This could lead to tripped 
breaker (at electrical panel) or tripped 
thermal overload (on compressor motor). 
If this occurs, eliminate extension cord and 
plug compressor directly into electrical 
outlet. Avoid using extension cords; use 
longer air hose(s) instead.