Datalogic Scanning QD2100 Benutzerhandbuch
Symbologies
148
QuickScan® QD2100
GS1 DataBar Expanded — cont.
GS1 DataBar Expanded Set Length 1
This feature specifies one of the barcode lengths for
GS1 DataBar Expanded Length
Control
. Length 1 is the minimum label length if in
Variable Length
Mode, or the first
fixed length if in
Fixed Length
Mode. Length includes the barcode’s data characters on-
ly.
The length can be set from 1 to 74 characters.
The length can be set from 1 to 74 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 74). Pad the number with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
Mode.
3. Scan the barcode: SELECT GS1 DataBar EXPANDED LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in
Appendix E, Keypad
, that represent
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
cation after the last character.
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
Mode.
This completes the procedure. See
Table 19
for some examples of how to set this feature.
Table 19. GS1 DataBar Expanded Length 1 Setting Examples
NOTE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
abort and not save the entry string. You can then start again at the beginning.
STEP
ACTION
EXAMPLES
1
Desired Setting
01 Character
07 Characters
52 Characters
74 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT GS1 DataBar EXPANDED LENGTH 1SETTING
4
Scan Two Characters From
Appendix E, Keypad
‘0’ and ‘1’
‘0’ and ‘7’
‘5’ and ‘2’
‘7’ AND ‘4’
5
Scan ENTER/EXIT PROGRAMMING MODE