TROY Group HP 2420 / 2430 Benutzerhandbuch
Font Card Installation Guide
Document #50-70409-001 Rev. A
Page 4 of 5
Hewlett-Packard 9050 Series Printers:
IMPORTANT:
Ensure the printer power is switched OFF, and then
disconnect the printer power cord from the AC wall outlet.
disconnect the printer power cord from the AC wall outlet.
1. Loosen the two thumbscrews (turn counter-clockwise) at the rear of the printer
(Figure 1 and Figure 2), and then carefully slide the formatter board out of the
printer (Figure 3).
printer (Figure 3).
Figure 1 Figure 2 Figure 3
2. Set the formatter board on a clean flat surface (Figure 4). Insert the font card into card slot #2 (center card
slot) as shown (Figure 5). The font card cannot be used in card slot #1. Do not remove or change the slot
positions of any existing cards. Ensure the font card is fully inserted and seated against the connector.
positions of any existing cards. Ensure the font card is fully inserted and seated against the connector.
Figure 4 Figure 5
Carefully slide the
formatter board
out of the printer.
formatter board
out of the printer.
Insert font card
into slot #2 only.
into slot #2 only.
1
2
3