Samsung C23A750X Benutzerhandbuch

Using "Central Station"

2 Using "Central Station"

This is achieved by an internal chip that transmits data received via the LAN cable to the PC as a

converted USB signal.

Connecting to a LAN via Wireless USB

Connecting to a LAN via USB cable

This product cannot connect to multiple source PCs at the same time and vice versa.

2.5

Configuring the Central Station Monitor IP

After installing the integrated driver for Central Station monitors, go to Control Panel

Network

and Internet

Network and Sharing Center

Change adapter settings.

You can see that the following two devices are displayed.

The user PC’s network device

The Central Station monitor’s network device (USB to Ethernet adapter)

The two devices above refer to your PC’s LAN network device and your Central Station monitor’s

network device.

To use the Internet using the Central Station monitor’s LAN network, configure the network settings as

follows according to the type of IP you will be using.

2.5.1

Dynamic IP

The dynamic IP address mode automatically configures the network settings on the PC using data sent

by a server, which allots an IP address. This is possible, owing to the “DHCP (Dynamic Host

Configuration Protocol)” service. The service consists of three steps: an IP address allotment request is

sent to the DHCP server when the PC boots up, the DHCP server that received the request transmits

LAN

USB CABLE

→