EVGA 132-YW-E178 Benutzerhandbuch

EVGA

8-pin ATX 12V Power (

PWR2

)

PWR2

, the 8-pin ATX 12V power connection, is used to provide power to the CPU. Align

the pins to the connector and press firmly until seated. This connector is notched, do not

force in.

Connecting IDE Hard Disk Drives

The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives.

Connect the blue connector (the cable end with a single connector) to the motherboard.

Connect the black connector (the cable with the two closely spaced black and gray

connectors) to the Ultra ATA master device.

Connect the gray connector to a slave device.

If you install two hard disk drives, you must configure the second drive as a slave device by

setting its jumper accordingly. Refer to the hard disk drive’s documentation for the jumper

settings.

If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are

attached to the same cable, the maximum transfer rate between the drives may be

reduced to that of the slowest drive.

GND

12V