IBM 4400 Benutzerhandbuch
186
Chapter
6
Configuring the Epson FX-1050 Emulation with Control Codes
Select Italic Character Set
ASCII Code ESC t
n
Hex Code
1B 74
n
Dec Code
27 116
n
Purpose
Selects the italics characters from hex 80 through hex FF, or
selects the graphics characters from hex 80 through hex FF.
selects the graphics characters from hex 80 through hex FF.
where:
n = hex 1 selects the graphics character set
n = hex 0 selects the italics character set
n = hex 0 selects the italics character set
Comment
The graphics character set is the IBM Graphics Code Page 437.
Select 9-Pin Graphics Mode
ASCII Code ESC ^
m n1 n2 d1 ... dk
Hex Code
1B 5E
m n1 n2 d1 ... dk
Dec Code
27 94
m n1 n2 d1 ... dk
Purpose
Turns on 9-pin bit image graphics mode.
Comment
m defines the plot density as shown in Table 42 on page 185.
(
(
n1 + 256n2) = The total number of columns.
This mode requires two bytes of graphic data for every column of
print. Each column is sent as a pair:
print. Each column is sent as a pair:
d1, d3, ... d(k-1) set the top
8 bits of a normal dot column, just like ESC K;
d2, d4, ... dk set
the ninth dot in the column (the most significant bit) just below
the bottom-most dot of columns
the bottom-most dot of columns
d1, d3, ... d(k-1).
Select Print Quality
ASCII Code ESC x
n
Hex Code
1B 78
n
Dec Code
27 120
n
Purpose
Selects print quality.
Comment
This command is ignored on thermal printers.