HP (Hewlett-Packard) 100BASE-TX Benutzerhandbuch

Installing and Configuring PCI 10/100 Base-TX

To manually set the duplex mode of the PCI ports, first ensure that your
computer has the latest applicable patches installed as listed in the
Required and Optional Patches section of this release note.

To list the current speed and duplex mode of the PCI
10/100Base-TX/9000 ports, use the

option (NOTE: lowercase x) of the

lanadmin command. Determine the speed and duplex mode of your hub
or switch before performing manual configuration as follows:

 (HP-UX 11.0)

To manually set the duplex mode of the interface, install one of the
patches above and then use the -

 option of

 as follows:

 (on HP-UX 11.0)

where:

 can be any one of the following strings (and the

 or

 are

case-insensitive):

=10 full-duplex

 =10 half-duplex

=100 full-duplex

 =100 half-duplex

and

 (turns autonegotiation on for HP-UX 11.0)

The

is the physical point of attachment on HP-UX 11.0. You can get

the

 from the output of the

 command.

Example:

If the

of the 100Base-TX interface is 5, the command to set the card

to 10Mbits/s and full-duplex mode would be:

After issuing the lanadmin -X, you must wait at least 11 seconds before
attempting to use the specified network interface.

If you want the Duplex Mode setting to be effective in all subsequent
reboots, you must enter the information in the following file:

Manually configuring the speed or duplex setting of a switch port on