Patton electronic 07M2160-GS Benutzerhandbuch

Introduction

Model 2160 Series Getting Started Guide 

This chapter provides information for configuring the Model 2160 by using the serial console with Telnet.

The console port is a RJ-48C connector that provides a connection to a PC for monitoring and configuring 
the Model 2160. Use the supplied serial cable with a female DB-9 connector to connect to the serial port of 
PC, and connect the RJ-48C module jack connector to the Model 2160's console port. Start your terminal 
emulation program (such as Hyper Terminal) and configure the communication parameters. Use the settings 
shown in 

 to log into the console:

After you enter the settings for the console, press the spacebar until the login screen appears. When you see the 
login screen, you can log on to the Model 2160. Enter admin for both the User Name and Password. 

The Model 2160 also supports Telnet for remote management. Connect the Ethernet cable to the MGMT 
port of Model 2160 to your computer. The MGMT LED on the front panel of the Model 2160 will light up. 
Start your Telnet client with VT100 terminal emulation and connect to the management IP of the Model 
2160. Wait for the login prompt to display. Enter your user name and password. When you see the login 
screen, you can log on to the Model 2160. Enter admin for both the User Name and Password.

The default IP address is 192.168.1.1. The line command is “telnet 
192.168.1.1” in DOS mode. 

Before changing the configuration, familiarize yourself with the operations list in the following table:

Table 14. Console settings

9600

8

None

1

None

Table 15. Interface commands

Move to the field above in the same level menu.

Move to field below in the same level menu.

Move back to the previous menu.

Move forward to the submenu.

Move to the first field.

Move to the last field.

Choose another parameter.

Quit configuring the item.

Access help.