I-Data 812-1x MIO Benutzerhandbuch

The installation of the  ida 812-1x MIO interface varies slightly
depending on the printer in which it is installed. This is decribed in
more detail below.

NOTE:
Irrespective of printer, you should first make sure
that power to the printer is turned OFF, and that
the correct language has been selected on the
interface DIP switch bank as described in
Section 2.1, DIP Switch Language Selection and
illustrated in Appendix B, DIP Switch Settings.

1.  Remove the HP MIO (Modular Input/Output) card from the 

bottom slot on the rear of the printer by loosening the screws 
and pulling the card out of the printer.

2. Insert the  ida 812-1x MIO interface (twinax connector  at the

bottom) in place of the card you just removed and tighten screws.

1. Loosen the screws on the cover plate positioned to the  left of 

the parallel and serial connection (on  the rear panel) and 
remove the plate.

2. Insert the ida 812-1x MIO interface (twinax connector  at the top) 

in the slot and tighten screws.

1.  Loosen the screws and remove the plate positioned on the rear 

of the printer.

2. Insert the ida 812-1x MIO interface (twinax connector  to the 

right) in the slot and tighten screws.