TP-LINK TD-W8970N Benutzerhandbuch

Seite von 116
TD-W8970N
  Wireless N ADSL2+ Modem Router User Guide
 
4.4.2.5  ATM-IPoA 
If your ISP provides an IPoA connection and you need to use an ATM Interface, follow the steps 
below to add a WAN service over a selected ATM interface. 
1.  Add a new ATM interface and select IPoA option for DSL Link Type (see 
2. Click 
the 
Add
 button on the screen Figure 4-7 and the next configuration is similar to IPoE 
). The difference is that you have to manually set the 
) 
Note: 
ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure 
any other WAN service over the ETH Interface until the ATM Interface is deleted. 
4.4.2.6  ETH-PPPoE 
If your ISP provides a PPPoE connection and you need to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface:   
1.  Add a new ETH interface on the screen of 
2. Click 
the 
Add
 button on the screen Figure 4-7 and the following configuration is similar to 
PPPoE 
over ATM interface (see section 
4.4.2.7  ETH-IPoE 
If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface: 
1.  Add a new ETH interface on the screen of 
2. Click 
the 
Add
 button on the screen Figure 4-7 and the next configuration is similar to IPoE 
over ATM interface (see section 
4.4.2.8  ETH-Bridge 
If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface: 
1.  Add a new ETH interface on the screen of 
2. Click 
the 
Add
 button on the screen Figure 4-7 and the next configuration is similar to Bridge 
over ATM interface (see section 
) 
Note: 
For ETH-PPPoE, ETH-IPoE and ETH-Bridge, the Bridging option will display in the screen of 
Figure 4-20 only when VLAN MUX Mode is selected for Connection Mode on the screen of Figure 
4-5
. You have to set the 802.1P Priority and 802.1Q VLAN ID
30