Epson T5270 Benutzerhandbuch
Epson SureColor T-Series User’s Guide
Problem Solver
168
Problem Solver
What to do When a Message is Displayed
If the printer displays one of the messages shown below, refer to the solution listed and take the necessary steps.
Messages
What to do
Ink Cartridge Error
Ink cartridge cannot be
recognized. Insert again or replace
ink cartridge.
Ink cartridge cannot be
recognized. Insert again or replace
ink cartridge.
O
Remove and reinsert the ink cartridge. If the message persists, insert a new ink
cartridge (do not reinstall the cartridge that caused the error).
cartridge (do not reinstall the cartridge that caused the error).
O
Condensation may occur in the ink cartridge. Leave it at room temperature for at
least four hours before installing the ink cartridge.
least four hours before installing the ink cartridge.
Ink Cartridge Error
Ink cartridge cannot be detected.
Insert again or replace ink
cartridge.
Ink cartridge cannot be detected.
Insert again or replace ink
cartridge.
Ink Cartridge Error
Please install the correct ink
cartridge.
Please install the correct ink
cartridge.
Insert a genuine Epson ink cartridge approved for use in the printer.
Ink Low
The ink is low. Ready a new ink cartridge.
Paper Load Error
Paper from Roll 1 cannot be
detected.
Paper from Roll 1 cannot be
detected.
Remove and then reload the roll paper in question.
Before you reset the paper, cut the edge of the roll paper straight horizontally. Cut off
any jagged or folded sections.
any jagged or folded sections.
If there is a problem with the edge, an automatic paper load error will occur.
Paper Load Error
Paper from Roll 2 cannot be
detected.
Paper from Roll 2 cannot be
detected.
F/W Install Error
Firmware update failed.
Restart the printer.
Firmware update failed.
Restart the printer.
Turn the printer off, wait for a few minutes, and then turn on the printer again.
Update the firmware again.
If this message appears on the LCD panel again, contact your dealer or Epson Support.
Command Error
Check driver settings.
Check driver settings.
Press the W button and select Job Cancel to stop printing. Confirm that the printer
driver you are using supports this printer.
driver you are using supports this printer.
Reel Unit Error
Check Auto Take-up Reel Unit and
restart printer.
Check Auto Take-up Reel Unit and
restart printer.
Turn the printer off, wait for a few minutes, and then turn on the printer again.
If this message appears on the LCD panel again, contact your dealer or Epson Support.
Reel Unit Error
Connect Auto Take-up Reel Unit
cable and restart printer.
Connect Auto Take-up Reel Unit
cable and restart printer.
After reconnecting the cable connecting the auto take-up reel unit to the printer, turn
the printer off and then on again.
the printer off and then on again.
U
The Setup Guide supplied with the optional auto take-up reel unit.
Reel Unit Disconnected
Auto Take-up Reel Unit is
disconnected. Do you continue?
Auto Take-up Reel Unit is
disconnected. Do you continue?
The auto take-up reel unit is not connected. After reconnecting the cable connecting the
auto take-up reel unit to the printer, select No to turn the printer off. Turn the printer
again after a short pause.
auto take-up reel unit to the printer, select No to turn the printer off. Turn the printer
again after a short pause.
U
The Setup Guide supplied with the optional auto take-up reel unit.
To continue printing without using the auto take-up reel unit, select Yes.