Epson T5270 Benutzerhandbuch

Seite von 213
Epson SureColor T-Series User Guide
Introduction
6
Introduction
Important Safety 
Instructions
Read all of these instructions before using the printer. 
Also be sure to follow all warnings and instructions 
marked on the printer.
When choosing a place for this 
product
O
Place this product on a flat, stable surface that is 
larger than this product. This product will not 
operate properly if it is tilted or at an angle.
O
Avoid places subject to rapid changes in 
temperature and humidity. Also keep it away from 
direct sunlight, strong light, or heat sources.
O
Avoid places subject to shocks and vibrations.
O
Keep this product away from dusty areas.
O
Place this product near a wall outlet where the plug 
can be easily unplugged.
When setting up this product
O
Do not block or cover the openings in this 
product’s cabinet.
O
Do not insert objects through the slots. Take care 
not to spill liquid on this product.
O
This product’s power cord is for use with this 
product only. Use with other equipment may 
result in fire or electric shock.
O
Connect all equipment to properly grounded 
power outlets. Avoid using outlets on the same 
circuit as copiers or air control systems that 
regularly switch on and off.
O
Avoid electrical outlets controlled by wall switches 
or automatic timers.
O
Keep the entire computer system away from 
potential sources of electromagnetic interference, 
such as loudspeakers or the base units of cordless 
telephones.
O
Use only the type of power source indicated on the 
product’s label.
O
Use only the power cord that comes with this 
product. Use of another cord may result in fire or 
electric shock.
O
Do not use a damaged or frayed power cord.
O
If you use an extension cord with this product, 
make sure the total ampere rating of the devices 
plugged into the extension cord does not exceed 
the cord’s ampere rating. Also, make sure the total 
ampere rating of all devices plugged into the wall 
outlet does not exceed the wall outlet’s ampere 
rating.
O
Do not attempt to service this product yourself.
O
Unplug this product and refer servicing to 
qualified service personnel under the following 
conditions:
The power cord or plug is damaged; liquid has 
entered the product; the product has been dropped 
or the cabinet damaged; the product does not 
operate normally or exhibits a distinct change in 
performance.
O
If you plan to use the printer in Germany, observe 
the following:
To provide adequate short-circuit protection and 
over-current protection for this printer, the 
building installation must be protected by a 10 or 
16 amp circuit breaker.
O
If damage occurs to the plug, replace the cord set 
or consult a qualified electrician. If there are fuses 
in the plug, make sure you replace them with fuses 
of the correct size and rating.
When using this product
O
Do not put your hand inside this product or touch 
the ink cartridges during printing.
O
Do not move the print heads by hand; otherwise 
you may damage this product.