Lexmark C772 Benutzerhandbuch
Adjusting Power Saver
80
Administrative support
Adjusting Power Saver
To adjust the Power Saver setting:
1
Make sure the printer is on and Ready appears on the display.
2
Press
on the operator panel.
3
Press
until
Settings
appears, and then press
.
4
Press
until
Setup Menu
appears, and then press
.
5
Press
until
Power Saver
appears, and then press
.
6
Using the right and left arrows on the operator panel, enter the number of minutes for the printer to wait before
entering Power Saver.
entering Power Saver.
The settings available range from 1–240 minutes.
7
Press .
Submitting Selection
appears.
Note: You can also adjust the Power Saver setting by issuing a Printer Job Language (PJL) command. For
more information, see the Technical Reference available on the Lexmark Web site at
www.lexmark.com/publications.
www.lexmark.com/publications.
Encrypting the disk
Warning:
All resources on the hard disk and RAM will be deleted.
Note: This setting is only available when a hard disk is installed.
1
Turn the printer off.
2
Press and hold
and
while turning the printer on.
3
Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4
Press
until
Disk Encryption
appears, and then press
.
5
Press
until
Enable
appears, and then press
.
Contents will be lost. Continue?
appears.
6
Press
until
Yes
appears, and then press
.
The Encrypting Disk progress bar appears.
7
When disk encryption has finished, press
.
8
Press
until
Exit Config Menu
appears, and then press
.
To disable disk encryption:
1
Turn the printer off.
2
Press and hold
and
while turning the printer on.
3
Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4
Press
until
Disk Encryption
appears, and then press
.