Sony SX-215 Benutzerhandbuch
User’s Guide
U
SING
A
THE
I
NTERNAL
C
OMMAND
C
ONSOLE
TO
C
ONFIGURE
THE
P
RINT
S
ERVER
:
The command console can be accessed using a Telnet connection via an Ethernet connection. To use a
Telnet connection, follow these steps:
Telnet connection, follow these steps:
1.
Ensure the print server is connected via an Ethernet cable to the host computer.
2.
From the Windows Start menu, click on Run, and then type the following command (where
x.x.x.x. is the IP address of the print server.
telnet X.X.X.X
After a connection is established, press RETURN or ENTER to get the ‘#’ prompt, enter the
password ACCESS (it will not ‘echo’ on your screen), and type anything in response to the Enter
Username> prompt. When you get the Local> prompt, you are ready to enter commands. Type
Help for a list of console commands.
password ACCESS (it will not ‘echo’ on your screen), and type anything in response to the Enter
Username> prompt. When you get the Local> prompt, you are ready to enter commands. Type
Help for a list of console commands.
First-Time Configuration of the Wireless Print Server Using 802.11b or
802.11g
(SX-215 wireless print server only)
It is recommended that you initially configure the print server via a wired connection. However, if you
choose to configure the wireless print server for the first time from a computer via an 802.11b or 802.11g
wireless connection, you will need to temporarily change the settings on your computer to match the
default settings of the print server as follows:
choose to configure the wireless print server for the first time from a computer via an 802.11b or 802.11g
wireless connection, you will need to temporarily change the settings on your computer to match the
default settings of the print server as follows:
Wireless Mode: Ad-Hoc (sometimes referred to as Peer-to-Peer)
Channel: 11
SSID (or wireless network name): printer
You should now be able to configure your print server using either the ExtendView Utility or the
Web Browser Configuration as described in the previous sections. For wireless security
configuration, see
Web Browser Configuration as described in the previous sections. For wireless security
configuration, see
Document #40181-420 Rev. B
20
NOTE: Be sure to set your PC back to its original wireless settings after you finish configuring the wireless print
server.
server.
NOTE: It is not necessary to change your computer’s settings if you are configuring the print server’s settings via
an Ethernet connection.
an Ethernet connection.