Sony UP-DR100 Benutzerhandbuch

O

per

at

ion

Adjusting Gray Balance

16

The printer cannot print in the following cases:
• When the remaining amount of ink ribbon or the 

quantity of printing is displayed on the information 
display because the MENU button was pressed and the 
printer is off-line, the printer cannot receive a print 
command from the computer.

• When an error message is displayed on the 

information display, you cannot operate the printer. 
Take remedies according to the advice given in “Error 
and Warning Messages” on page 25.

• Avoid exposure to direct sunlight, or conditions of 

high temperature and high humidity, which could 
cause the colors to fade.

• Avoid applying tape to a printout, and avoid contact 

with plastic objects such as erasers and desk mats.

• Do not allow alcohol or other volatile organic solvents 

to come into contact with the printouts.

The gray balance differs between different packages 
where ink ribbons and papers are contained as a set. To 
avoid imbalance, use the ink ribbon with the paper that 
is supplied as a set in the same package. Also, when a 
new ribbon and paper are loaded, we recommend that 
the gray balance be adjusted. The gray balance of the 
printer is set to No.0 as the factory setting. This setting 
is retained even when the printer is turned off.

The gray balance of images cannot be adjusted during 
printing. 

Press the CALIBRATION button.
The ONLINE indicator goes off and the printer is 
switched to off-line.

Press the 

F and f buttons to select GRAY PATCH 

PRINT.

Press the EXEC button.
The printer returns to the on-line mode and starts 
printing.
When using the UPC-R35/R35A or UPC-R46/
R46A, gray adjustment patterns Group A and 
Group B are printed on two sheets separately.
When using the UPC-R57/R57A or UPC-R68A, 
gray patterns Group A and Group B are printed on 
one sheet.

ONLINE indicator

Press 

F

 and 

f

 to display GRAY PATCH PRINT.