Kodak 8670 Benutzerhandbuch

Part No. 6B4389

June 1999

3-19

You must be on the same Ethernet segment to use the arp -s 
command. There cannot be a router between the NIC and the 
system using ARP. 

The arp mechanism will only enable that workstation to access 
the NIC using the IP address used in the arp command. It is still 
necessary to set that IP address on the NIC using any NIC 
configuration utility in order for that IP address to be saved on the 
NIC.

To use arp on Windows: 

1.

From the MS-DOS prompt use the arp -s command to enter 
the IP address into the NIC as shown in the following 
example:

arp -s 192.189.207.77 00-40-17-00-ed-d6

Substitute your actual IP address for 192.189.207.77, and 
replace the 00-40-17-00-ed-d6 with the actual Ethernet 
address of the NIC.

2.

Use the ping command with the NIC’s IP address to verify the 
connection. For example:

ping 192.189.207.77 

Substitute your actual NIC IP address in 192.189.207.77 in 
the above examples. You should get a response back from 
the NIC if the IP address has been set and the NIC installed 
in the printer is alive on the network.

To use arp, enter the following command at the UNIX system 
prompt:

arp -s ipaddress ethernetaddress temp

Ethernetaddress is the Ethernet address of the print server, and 
IPaddress is the IP address of the print server. For example: 

arp -s 192.189.207.2 00:40:17:00:c3:e4 temp