Kodak 8670 Benutzerhandbuch

7-2

Part No. 6B4389   June 1999

The following are the steps you need to complete to set up your 
printer for network printing:

1.

Set up the printer. Refer to the QuickSetup card or the 
Operator’s Guide that is included on the CD for instructions 
on setting up your printer.

2.

Install the NIC in the printer and connect it to an Ethernet 
network. Refer to Chapter 2 for instructions on installing the 
NIC and Ethernet cable.

3.

Obtain an IP address for the printer (NIC). Assign the IP 
address to the printer (NIC) using the printer’s front control 
panel or by using remote NIC configuration tools.

4.

Print a NIC configuration page to verify that the installation is 
correct. Refer to Chapter 2 for instructions on printing a NIC 
configuration page.

5.

Configure network communications using TCP/IP on each 
workstation or server that will be communicating directly with 
the printer.

NOTE: Configuring network communications between workstation 

clients and servers is beyond the scope of this manual. For 
client/server environments, it is presumed that a functional 
client/server network environment already exists. 

6.

Install the printing software (AdobePS driver for and PPD for 
PostScript printing and/or export module for raster printing) 
on each workstation that will be sending jobs to the printer.

Novell Netware 5.x supports communications using TCP/IP. Prior 
versions (3.x, 4.x) support IPX and AppleTalk Print Services, but 
do not support TCP/IP. Refer to your Novell Netware 5.x 
documentation for communications using TCP/IP and configuring 
print queues.