Kingston Technology KND2415TX Benutzerhandbuch
KND2415TX Users Guide - Rev. A00
Kingston Technology Company
Hardware Installation
7
Stack-In / Stack-Out Ports
Fig. 3-4 Stacking Conguration
The Fast EtheRx stackable hub uses stacking ports located on the back of the unit
to stack up to a maximum of four hubs.
IMPORTANT: The KND2415TX can only be stacked with other KND2415TX
units. Stacking the unit with any other model hub may cause damage to the
units.
Follow the directions below on stacking these hubs together:
1. Power down the Fast EtheRx hub(s).
2. Locate the 50-pin shielded stacking cable included with your package
2. Locate the 50-pin shielded stacking cable included with your package
contents.
3. Plug one end of the cable into the port labeled, “Stack-Out” on the rst
3. Plug one end of the cable into the port labeled, “Stack-Out” on the rst
hub.
4. Plug the other end of the cable into the “Stack-In” port on the second hub.
5. Repeat steps 2 through 4 for stacking up to a maximum of four (4) hubs.
Kingston’s Stack-n-Play™ feature offers greater scalabilty to add UTP ports
4. Plug the other end of the cable into the “Stack-In” port on the second hub.
5. Repeat steps 2 through 4 for stacking up to a maximum of four (4) hubs.
Kingston’s Stack-n-Play™ feature offers greater scalabilty to add UTP ports
without the need to congure ID or termination switches. When congured as
a stack, the Fast EtheRx stackable hubs are recognized as a single unit on the
network. By stacking hubs together, you can expand the total number of UTP ports
up to 96 ports.