Fujitsu eLux NG S26361-F2600-L134 Benutzerhandbuch

 

 

 

 

 

 

Build # 27

  

93

 

•  Always required A smart card is required when the Thin Client boots and during 

the entire eLux NG session. If the user removes the card, the session will be 
locked. A smart card and valid PIN are required to unlock the terminal. 

•  Required on startup A smart card is required only when the Thin Client starts. 

The local user can remove the card without interrupting the eLux NG session.  
 

3.  If the information saved on the smart card includes a domain name, go to the Network 

tab, click Advanced, and enter the domain name in the Smart Card domain field. 

Figure 61: Smart card domain field in Setup > Network > Advanced network settings dialog box 

4.  Save your changes. 

 
Security settings have now been activated. Depending on the security settings you chose 
(step 2), the smart card screen will appear at system start and whenever the card is removed 
during the session, or at system start only. The smart card screen instructs the local user to 
insert a smart card into the card reader and enter a PIN. The user is blocked until this is done. 
 

 Do not mistype the PIN! If an invalid PIN is entered three times, the card is locked 

and can no longer be used. It must be reset by the smart card administrator using the 
SICRYPT

®

 SMARTY 2 software.  

 

Troubleshooting 
Following is a list of the most frequent error messages. 
 

 

The card is locked 

The card has been locked. See your smart card 
administrator with SMARTY 2 software to unlock. 

 

No card reader was 
detected 

The card reader is missing. Please attach a card 
reader and reboot. 

 

Domain mismatch 

The domain name saved to the smart card is not the 
same as the domain entered in eLux NG. 

6d00  Cannot read card 

The card is not supported. Please use cards coded 
with SMARTY 2. 

6301  PIN mismatch 

Invalid PIN. You have one more attempt to enter the 
correct PIN. 

6302  PIN mismatch 

Invalid PIN. You have two attempts remaining to enter 
the correct PIN. 

 
If the smart card does not work, you can access the device by performing a factory reset. For 
security reasons, all configuration information is deleted. See “5.3 Factory Reset.”