Barco DCS-200 Benutzerhandbuch

Using the Setup Menu

The following sections provide detailed information about Preview Menu functions:

In the Preview Menu, choose Output Src to select the source to be displayed on the 
preview monitor. The  source can be either Preview or Program. 

Choose Preview to display on the preview monitor the “pending” source.

Choose Program to display on the preview monitor the same source that is on 
Program.

In the Preview Menu, the [output_format] field displays the format of the output, in the 
following form:

S

1024x768@59.94

The output format for the DCS-200 can be set to any of the progressive outputs in the 
format table.  In Appendix A, refer to the “

” section on page 122 for details. 

To make pixel-for-pixel adjustments, set the Preview and Program resolutions to be the 
same, as shown in the following illustration:

Figure 4-18.  Matching Preview and Program Resolutions 

 If you do not need to make pixel-perfect adjustments to the Preview image, the resolutions 
of the Preview and Program outputs do not need to be the same, as shown in the following 

 

In Preview mode, when you press KEY to “pend” the key 
transition, you will not see the key overlay on the preview 
monitor.  If you then press TAKE,  the input and key appear 
on Program.

To see the key on the preview monitor, you can route the 
source from Program to preview using the Output Src 
selection of the Preview Menu. This selection places a copy 
of the Program image on the preview monitor, including the 
key. For more information about keys, see the “

section on page 95.

The output format is not updated until you press SEL.