Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Trendnet
  4. 10/100Mbps mini Print Server
  5. Benutzerhandbuch

Trendnet 10/100Mbps mini Print Server Benutzerhandbuch

Download
Seite von 72
 
Chapter 2
 
LAN Installation 
This chapter describes how to install the Print Server in your Local Area Network. 
Procedure 
1. Preparation 
•  Ensure the power is OFF. Do not connect the Print Server while power is On. 
•  Find the Default Server Name for your Print Server. The Default Server Name is shown on 
a sticker on the base of the device. It consists of 8 letters and/or digits. Record this name; it 
may be needed during configuration. 
2. Connect the Printer 
•  For the TE100-P1U, use the cable supplied with your printer to connect the printer to the 
USB port on the Print Server unit. 
•  For the TE100-P1P, connect the male parallel port on the Print Server directly to the 
printer. 
3. Connect the Network Cable 
•  Connect the network cable to the 10/100BaseT LAN connector on the Print Server. 
4. Power Up 
Plug in the power adapter cable and power up. Start-up will take only a few seconds. 
Use only the Power Supply unit provided with the Print Server. Using a different Power 
Supply may cause damage. 
5. Check the LEDs 
•  The Error LED should flash, then turn Off. When the Error LED goes off and the Status 
LED remains lit or flashes, the Print Server is ready. 
•  On the TE100-P1P, either the 10BaseT (yellow) LED or the 100BaseT (orange) LED 
should be On. 
•  On the TE100-P1U, the Error LED will remain flashing if the Print Server can't connect to 
the USB printer. 
 
Page 6