Lucent Technologies 555-233-115 Benutzerhandbuch
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
Upgrading R5si/R6si to R8r EPN and Adding Memory
3-9
Preliminary Procedures
3
Check Software Release Letter
1. Check the
Software Release Letter that accompanies the Release 8
removable media. This letter contains the recommended upgrade
procedures. Always use the
procedures. Always use the
Software Release Letter when upgrading a
system.
2. If the letter is not included with the Release 8 removable media, perform
the following procedures.
Busyout Multimedia Interface Circuit Packs
Perform this step only if the system is high or critical reliability and contains
MMCH circuit packs. Multimedia-to-voice station calls are
MMCH circuit packs. Multimedia-to-voice station calls are
not preserved on an
upgrade. Failure to busy-out the TN787 Multimedia Interface circuit packs will
result in unusable TN787 and TN788 Multimedia Voice Conditioner ports.
result in unusable TN787 and TN788 Multimedia Voice Conditioner ports.
1. Type display system-parameters customer-options and press
Enter
. If
.
2. Type list configuration all and press
Enter
. Locate all of the TN787
Multimedia Interface circuit packs.
3. Type busyout board <location> and press
Enter
for each TN787. This
prevents any further multimedia-to-voice connections and drops all active
connections.
connections.
Save Translations and Announcements
1. Log in at the management terminal on the Release 5/6 system.
2. If the system is duplex, type status system and press
Enter
to verify the
system is in the ‘‘active/standby" mode.
3. Type save translation and press
Enter
. This instructs the system to write all
translation information from memory to the translation cards.
4. Check for translation errors before proceeding with the upgrade. If errors
are detected, refer to
to correct the problem. Do not continue
until the errors are corrected.
5. If the system contains a TN750/B Announcement circuit pack, type
display announcements and press
Enter
.
6. If administered recorded announcements are listed, type save
announcements and press
Enter
.
7. Remove the translation card and install the backup removable media or
card.