Delta 20-400 Benutzerhandbuch

13

See Figure 14.
You can tilt the band saw table up to 45° to the right. To 

tilt the table to the right.

•  Loosen the black table tilt locking wing nut (A), 

located underneath the lower trunnion. 

•  Tilt the table to the desired angle as shown on the tilt 

scale (B). 

•  Retighten the table tilt locking wing nut. 

The table can also be tilted 3° to the left for 

applications such as cutting cast moldings. To tilt the 

table to the left:

•  Follow the instructions above and tilting the table to 

the right. The table should be tilted enough to allow 

access to the 0° stop bolt (C) located on the lower 

trunnion. 

•  Remove the 0° stop bolt.
•  Loosen the table tilt locking wing nut, tilt the table all 

the way to left.

•  Retighten the table tilt locking wing nut. 

IMPORTANT: Proper positioning of the upper blade 

guide is required to ensure an accurate cut. It also 

serves to prevent operators fingers from coming in 

contact with the saw blade. 
See Figure 15. 
The upper blade guide (A) should be positioned 

approximately 1/16" above the top of the workpiece, 

just high enough to allow the workpiece to pass under 

the blade guide assembly. 
To set the upper blade guide to the proper height: 

•  Loosen the lock knob (B) and move the blade guide 

assembly to the desired position.

•  Retighten the lock knob.

IMPORTANT: Prior to using the band saw, always 

check guide post lock knob and tighten if necessary.