Cornelius 3 Benutzerhandbuch

Viper Service Manual                                   

Publication Number: 621360041TBSER

- 44 -

© 2010, IMI Cornelius Inc.

There are several procedures that should be completed on a semi-annual basis. 
There procedures help to insure proper operation of the system on a long term 
basis. Refer to Table 33 for a listing of the semi-annual maintenance items.

Scraper blades should be inspected for wear during the semi-annual mainte-
nance check. To inspect the blades, perform the procedure in Table 35

Syrup connections should be cleaned at least every six months, or when syrup 
types are changed. Perform the procedure in Table 36 to clean the BIB connec-
tors.

1. 

2. 

When purging is complete, remove power from the unit.

3. 

Remove the four (4) 3/4 in. nuts from the faceplate and slowly remove the 

faceplate from the unit.

4. 

Slowly pull the blade assembly out of the barrel.

5. 

Rinse and inspect the blade assembly for signs of wear.

6. 

If there is significant wear on the blades, Reverse or replace them, depending 

on the wear pattern.

7. 

Replace the blade assembly and bushings (PN 2392) onto the motor shaft in 

the barrel.

8. 

Re-install the faceplate and replace the four (4) mounting nuts. Hand tighten 

the nuts untill the faceplate makes contact with the gasket, then use a wrech 

to tighten the nuts an additional 1/4 turn. Be careful not to over tighten the nuts 

or cracking of the faceplate may result.

9. 

Refill the barrel with product. See “Filling a Barrel” on page 29.

10. 

When barrel fill is complete, perform a motor calibration. See “Calibrating a 

1. 

Open the merchandiser and select OFF for the barrel to be cleaned.

2. 

Remove the quick disconnect from the BIB container.

3. 

Fill a suitable pail or bucket with soap solution.