GE ZVC36 Benutzerhandbuch

ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE 
THE FOLLOWING:
A. Use this unit only in the manner intended by the 

manufacturer. If you have questions, contact the 
manufacturer.

B. Before servicing or cleaning unit, switch power off at

service panel and lock the service disconnecting means 
to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag,
to the service panel.

For General Ventilating Use 

Only. Do Not Use To Exhaust Hazardous Or Explosive
Materials And Vapors.

ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE 
THE FOLLOWING:
A. Installation work and electrical wiring must be done by

qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction. 

B. Sufficient air is needed for proper combustion and 

exhausting of gases through the flue (chimney) of fuel 
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society 
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.

C. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

D. Ducted fans must always be vented to the outdoors.
• Local codes vary. Installation of electrical connections 

and grounding must comply with applicable codes. In 
the absence of local codes, the vent should be installed 
in accordance with National Electrical Code ANSI/NFPA 
70-1990 or latest edition.

– 

Save these instructions for local

inspector’s use.

– 

Observe all governing codes 

and ordinances.

• Note to Installer – Be sure to leave these 

instructions with the Consumer.

• Note to Consumer – Keep these instructions for

future reference.

• Skill Level – Installation of this vent hood requires

basic mechanical and electrical skills.

• Completion time – 1 to 3 hours.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not 

covered under the Warranty.

Due to the weight and size of these vent  hoods and 
to reduce the risk of personal injury or damage to the
product, TWO PEOPLE ARE REQUIRED FOR PROPER
INSTALLATION.

To reduce the risk of fire or electrical shock, do not use
this range hood with any external solid-state speed
control device. Any such alteration from original factory
wiring could result in damage to the unit and/or create
an electrical safety hazard.