Emerson I-0021 Benutzerhandbuch
3
Startup and Operation, General Notes and Main Menu
90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98
NGA 2000
3 - 7
3.8
Main Menu
If you press the F3 key (Main...) or the
→
→
-key in any single component display, you
will change to the "Main Menu". From there you can change to all operating levels
of your MLT analyzer or analyzer module to set up and control the parameters of
measurement, calibration and data transfer !
Via the F5 key (MFG Data) you can change to several submenus, where you will find
a lot of important data about the control module (MLT analyzer or platform) and the
analyzer module, such as service address or serial number !
of your MLT analyzer or analyzer module to set up and control the parameters of
measurement, calibration and data transfer !
Via the F5 key (MFG Data) you can change to several submenus, where you will find
a lot of important data about the control module (MLT analyzer or platform) and the
analyzer module, such as service address or serial number !
Ramifications from the Main Menu:
F1
Changing to the single component display of the
current channel
current channel
+
F2
Changing to the menu "Analyzer Channel Status" of
the current channel
the current channel
+
F3
Scrolling through all channels of the connected
analyzers and analyzer modules
analyzers and analyzer modules
+
See channel tag !
F4
Lock of any operating level by security code
+
F5
Changing to the menu "Module Manufacturing Data"
+
Factory Setting
Measure
Status...
Channel
Lock...
MFG Data
TAG
F1
F2
F3
F4
F5
95.00 ppm
-- Main Menu --
Analyzer module calibration & basic controls...
Analyzer and I/O-module expert configuration...
System configuration and diagnostics...
Display controls...
Time & Date:
14:01:45 25 May 1998
System tag:
Fisher-Rosemount